The lab type decides what the student starts with. Pick Wire to practise wiring, Install to test choosing and mounting the right parts, and Debug to test fault-finding. You choose it under Lab type after you pick a lab.

The Lab type control in Create Assignment showing Wire, Install and Debug.
Choose the lab type after you pick a lab. Hover over a greyed-out option to see why.

Wire

“Students wire the pre-placed gear from scratch.” The parts are already mounted and the student makes the connections. Wire is the only type where students can use the AI Tutor and where the ladder diagram lights up as their wiring becomes correct, so it’s the best choice for learning and practice.

Install

“Students install the gear themselves, then wire it.” Only the power source and disconnect are already installed and wired. The student reads the parts list on the assignment, picks the parts, mounts them and wires them. If the installed parts don’t match the job, points come off the score. The AI Tutor is off, and the ladder diagram is a reference drawing only.

Debug

“Students find and repair the authored fault wiring.” The circuit arrives wired but faulted. The student finds the problem and fixes it, and can remove only a limited number of wires. The AI Tutor is off, and the ladder diagram doesn’t light up.

Why an option is greyed out

Hover over a greyed-out option to see the reason. The ⓘ next to Lab type explains:

  • Debug needs fault wiring and a wire-removal limit set up in the Lab Builder.
  • Install needs the power source and disconnect pre-installed and pre-wired in the Lab Builder, and the lab’s author must have turned Install on.
  • Wire can be turned off by the lab’s author. You’ll see: “This lab is not offered as a Wire lab.”

Lab authors turn each type on or off on the Scenarios tab in the Lab Builder.

Common problems

  • I can’t turn on AI Tutor. It’s always off on Install and Debug labs and on exams. Your choice is kept if you switch the assignment back to Wire coursework.
  • Install is greyed out on my own lab. Open the lab in the Lab Builder, go to Scenarios, turn Install on and choose which parts the student installs. Then publish the lab again.